How to configure IP camera connected via PoEįor the network cameras connected with PoE NVR via PoE ports, you can not view or configure them on web directly because the IP network segments of IP camera and your PC are different. Please keep clicking on the “Refresh” till “Connected” comes out. If you have done the right steps, but you find that the state is “Disconnected”.
#Sostatus tech password
Just refresh, then you will find that it has been connected in Port3 without verifying password and the IP address has been changed into 192.168.20.xx. Pull out the IPC1 and edit the IP address into 192.168.7.151, but don’t change the password. On the contrary, you need to verify the password if you changed the password of the IP camera.įor example:IPC1 :192.168.20.2password: ms111111 Then input the exact password “123456” and click on “OK”.Īfter saving the password, the status will be shown as by clicking on the button “Refresh”.ģ) If the IP camera has ever been connected into the random PoE port, even if its IP address changes after being pulled out, as long as the password dose not change, you can plug in random PoE port without verifying password anymore. Then input the exact password “ms123456” and click on “OK”.Īfter clicking on the button, it will pop up a window as follows. There are two ways to edit password to make the IP camera connected:Ĭhoose the IP camera, and then click on “Edit Authentication”.Īfter clicking on the button, it will pop up a window as follows. The password of the IP camera is not the same as the channel, so status will be shown as. ġ) When the password of the IP camera is not same with the NVR, we can make it connected through editing the exact password of the IP camera.įor example:NVR: 192.168.7.150Password: ms111111 You will find that the IP address has been changed into 192.168.20.xx. 1) It can plug and play as long as its password is same with the NVR.įor example: NVR: 192.168.7.150Password: ms111111.When you put the IP camera into the PoE port, When you activate a NVR, the NVR password will also be used to activate the PoE channels. They can be directly used to connect to the Milesight cameras.įor MS-N1004-UPC, the default IP address of the 4 PoE channels are 192.168.20.xx. įor the PoE ports, each port has a fixed number like the above picture showing.
And you can log-in the NVR to manage it via web by using the IP address. You can set the local IP for the NVR via Smart Tools which you can download from the official website of Milesight. Intuitively, there is one LAN port and four PoE ports in the MS-N1009-UPT.įor the LAN port, the default IP address is 192.168.5.200.
0 kommentar(er)
